PRODUCT DESCRIPTION: XYLAN 1014/P01931E DEEP MED. BLUE #524 PRODUCT CODE: P01931E GENERAL INFORMATION: The primary end use for this coating is: DRY FILM LUBRICATING COATING PRODUCT SPECIFICATIONS: SOLIDS, theoretical: 30.00 ± 2.0% by wt., 19.88 ± 2.0% by vol. DENSITY, theoretical: 9.00 ± 0.2 lb/gal, 1.08 ± 0.02 Kg/liter COVERAGE, theoretical: 318.87 sq.ft./gal.@ 1 mil, 7.24 sq.m./Kg.@ 25 microns VISCOSITY, as shipped: 25 - 35 SECONDS ZAHN #3 (S90) CUP at 77°F (25°C) TYPICAL PROPERTIES: FLASH POINT: 85°F, 29°C VOLATILE ORGANIC CMPDS: 6.42 lb./gal., 770.40 grams/liter PREPARATION OF PARTS FOR COATING: Parts must be free of dirt, oil and other soils to achieve good adhesion and defect free coatings. The following are the recommended substrates and substrate preparations used with this coating: SUBSTRATES: MOST METALS, SOME CERAMICS AND PLASTICS PREPARATION: DEGREASE; LIGHT GRITBLAST RECOMMENDED; ZINC PHOSPHATE ON STEEL RECOMMENDED; MAY BE USED OVER ETCHED ZINC PLATE. PRIMERS: MAY BE USED OVER XYLAR 1, 2 OR XYLAN 4090 SERIES PRIMERS. PREPARATION OF COATING MATERIAL: Mix containers thoroughly by shaking or stirring until any solid material on the bottom has been eliminated. Best results are obtained when the coating temperature is 65-90°F (18-32°C). Adjust viscosity, if necessary, using the recommended thinner and an accurate Zahn Viscosity Cup. Other viscosity cups may also be used. Add thinner in increments of 2% until proper viscosity is achieved. Low viscosity produces runs and sags and low film thickness. High viscosity produces poor sprayability and uneven appearance. Any dried coating or dirt may be removed by passing the coating through a 100-200 micron filter. APPLICATION VISCOSITY: 25 - 40 SECONDS ZAHN #2 (S90) CUP AT 77°F (25°C) VISCOSITY ADJUSTMENT: NMP/XYLENE - 2:1 OR SOLVENT 99B, AS NEEDED. OTHER INFORMATION: AVOID CREATING FOAM WHILE MIXING. _________________________________________________________________________________ NON-WARRANTY. The information presented in this publication is based upon the research and experience of Whitford and is to the best of its knowledge accurate; however, no guarantee of its accuracy is made, Since Whitford has no control over the conditions under which its products may be employed; and since information as to the physiological and other properties of its products is incomplete, Whitford cannot guarantee the results obtained and assumes no liability whatsoever for possible damage or injury whether or not caused by following the suggestions in this brochure. Whitford will not be liable for resulting or consequential damage. Whitford warrants that none of its commercial products infringes the claims of any United States patent but no license is granted nor recommendation made hereby to practice any invention covered by any patent owned by Whitford or by others.